KitchenRisk
Decision dossierEvidence reviewed
commercial dishwasher

Jackson TempStar HH-E: Used-Buy Risk, Parts & What to Check

Jackson TempStar HH-E used-buy guide: verified $7,500 price, top failure points (wash heater, pump seal, rinse solenoid), and pre-purchase checklist.

Status: published
Used range$7,500–$7,500
Recallnone found
Known risks5
Sources4
Verified2026-09-14
Buy-Risk Verdict
Inspect before buying · moderate confidence
Short answer: Verified used price $7,500 (vs. $16,986 new); biggest risk is wash-heater/thermostat drift affecting sanitizing temperature compliance, inspect wash pump seal, rinse solenoid, and door gasket service history before buying. Used examples run about $7,500. Basis: jacksonwws.com.

Last verified against the primary source on Sep 14, 2026.

Decision status
inspect

Verified used price $7,500 (vs. $16,986 new); biggest risk is wash-heater/thermostat drift affecting sanitizing temperature compliance, inspect wash pump seal, rinse solenoid, and door gasket service history before buying.

Confidence 60%
Market context
Not yet verified

1 observed comparables

As of Sep 14, 2026
Repair Risk Matrix

What can make the cheap machine expensive?

ComponentSeverityDocumented repair cost
Drain valve / standpipelownot yet verified
Wash pump seal / hose clampsmedium

OEM troubleshooting table: "Water leaks at wash pump. 1. Wash pump seal defective. 2. Petcock or pump drain (if equipped) not shut/tight. 3. Loose hoses (hose clamps) on the wash pump." Remedy: "1. Replace seal. 2. Close or tighten. 3. Tighten hose clamps." Wear item excluded from factory warranty per manual.

Cost not yet verified
Rinse solenoid valve / cycle timermedium

OEM troubleshooting table: "Will not rinse during autocycle. 1. Defective rinse solenoid. 2. Faulty timer. 3. No water to the machine." Multiple root causes gate the same symptom, complicating used-unit diagnosis without service history.

Cost not yet verified
Wash tank heater element and thermostathigh

OEM troubleshooting table: "Wash water is not reaching required temperature. 1. Faulty wash heater. 2. Misadjusted/faulty thermostat(s). 3. Wash thermometer is defective." Sanitizing temperature is a health-code requirement, making this the highest-stakes failure mode on the platform.

Cost not yet verified
Door spring assembly and door channellow

OEM troubleshooting table: "Door will not close completely. 1. Improper spring tension. 2. Obstruction in door channel. 3. Door panels are not square with frame." Mechanical wear item, generally low-cost to correct.

Cost not yet verified
Drain valve / standpipelow

OEM troubleshooting table: "Machine doesn't drain when power switch is flipped to \"OFF.\" 1. Drain clogged. 2. Standpipe not removed before draining." Often operator error rather than a component failure.

Cost not yet verified

Common questions

How much does a used Jackson TempStar HH-E cost?

We have one observed listing, at 7,500 (as of 2026-09-14). One listing is not a price range, so treat it as a single data point.

What fails on the Jackson TempStar HH-E?

The most cited concerns in our evidence record: Drain valve / standpipe. See the risk breakdown above for details and sources.

Reference list

Sources

  1. jacksonwws.commanual · verified-primary · accessed 2026-09-14
  2. webstaurantstore.comweb · verified-primary · accessed 2026-09-14
  3. cityfoodequipment.comweb · verified-primary · accessed 2026-09-14
  4. surreyfoodequipment.comweb · verified-primary · accessed 2026-09-14
Spot an error? Challenge this record

Found an out-of-date code section, a wrong verdict, or a better primary source? Tell us. Corrections that check out are applied, with the change shown in history. That is our standing policy.